Connecting A Cd-R/Rw Drive To The Vs-2480; Connecting A Zip Drive To The Vs-2480 - Roland VS-2480 Owner's Manual

Connecting a CD-R/RW Drive to the VS-2480

Before connecting a CD-R/RW drive to the VS-2480, turn off power to all of your
devices—including your speakers—to prevent damage to your equipment.
1. Double-check to make sure that both the CD-R/RW
2. Connect a SCSI cable from one of the CD-R/RW's
3. If the CD-R/RW is the only SCSI device connected to
4. If you've changed either device's ID, make sure that
5. Turn on the power to the CD-R/RW drive.
6. Turn on the VS-2480's power.
You should always power up its SCSI devices before turning on the VS-2480.
7. Turn on the remainder of your equipment.

Connecting a Zip Drive to the VS-2480

Before connecting a Zip drive to the VS-2480, turn off power to all of your devices—
including your speakers—to prevent damage to your equipment.
1. Double-check to make sure that both the Zip drive and
2. Connect a SCSI cable from one of the Zip drive's SCSI
3. If the Zip drive is the only SCSI device connected to
4. Make sure that the Zip drive's SCSI ID number is set
5. Turn on the power to the Zip drive.
6. Turn on the VS-2480's power.
You should always power up its SCSI devices before
turning on the VS-2480.
7. Turn on the remainder of your equipment.
Roland VS-2480 Owner's Manual
drive and the VS-2480 are turned off. If there are any
other SCSI devices connected to the VS-2480, make
sure they're powered down as well.
SCSI jacks to the VS-2480's SCSI jack (Page 48), as
shown here.
the VS-2480, make sure its terminator switch is turned
on. If the drive has no terminator switch, plug a
terminator plug into its second SCSI jack.
The factory setting for the VS-2480 is SCSI ID 7. The
factory SCSI ID for a Roland VS-CDRII and CD-RACK
is ID 4.
the CD-R/RW's SCSI ID number is set to a different
number than the VS-2480.
the VS-2480 are turned off. If there are any other SCSI
devices connected to the VS-2480, make sure they're
powered down as well.
jacks to the VS-2480's SCSI jack (Page 48), as shown.
the VS-2480, make sure its terminator switch is on.
to a different ID number than the VS-2480. The factory
setting for the VS-2480 is SCSI ID 7.
29—Expanding the VS-2480
www.rolandus.com
PS / 2 MIDI
SMPTE
KEYBOARD MOUSE
IN OUT / THRU / IN
SCSI VGA OUT
PS / 2 MIDI
SMPTE
IN KEYBOARD MOUSE OUT / THRU / IN
SCSI VGA OUT
381