Roland VS-2480 Owner's Manual page 198

14—Working with Track Channels
To clear all of the current connections to a destination track, hold down its TRACK
STATUS button and press CLEAR. To quickly clear all of the QUICK ROUTING
screen's connections, press F4 (AllClr).
3. Press the FADER button for the set of track channels that contains a
4. Press the source track channel's SELECT button—a virtual wire
5. Repeat Step 3, if necessary, and Step 4 for any other tracks you want to bounce.
for Track Channels
Track Channels 5-7
hard disk recorder
6. When you're done, press F6 (EXIT) to confirm the routing and leave Quick Routing.
Setting Up EZ Routing for a Bounce
1. Press EZ ROUTING.
2. If the ROUTING VIEW screen doesn't appear, and you see "VIEW" above F1, press
198
source track channel.
appears on the screen to show the connection you've made.
We pressed
Track Channel
5's SELECT
button
If you want to break the connection, press SELECT again.
We pressed the
SELECT buttons
6 and 7—we're
now bouncing
to Track 1 on the
Hard Disk
Recorder
Tracks 1-24
Track
channels
1-24
F1 (VIEW). If you don't see "VIEW" above F1, press PAGE and then F1 (VIEW).
www.rolandus.com
The gray arrows at the
left edge of the screen
show the direction in
which signal flows.
When you're bouncing
tracks, signal flows up
from the track
channels to the hard
disk recorder tracks.
The gray arrows at the
left edge of the screen
show the direction in
which signal flows.
When you're bouncing
tracks, signal flows up
from the track
channels to the hard
disk recorder tracks.
The gray arrows at the
left edge of the screen
show the direction in
which signal flows.
When you're bouncing
tracks, signal flows up
from the track
channels to the hard
disk recorder tracks.
Roland VS-2480 Owner's Manual
TR 1-16 TR 17-24
FX RTN
V.FADER
MASTER
EDIT