Roland VS-2480 Owner's Manual page 335

Edit point:
FROM
TO
When you move Automix data to a new location, it replaces any Automix data already
present in the destination location.
INSERT
Insert adds an area of blank space at the IN location equal to the length of the selected
Automix region—all data at the IN point and onward is moved so that it starts at the
end of the inserted blank space. When you've inserted empty space in an audio track,
you'll want to insert space in the accompanying Automix track as well so that your
Automix events line up properly with their corresponding audio data.
CUT
CUT deletes the Automix events between the IN and OUT points and moves the
remaining data forward so that it starts at the IN point. You might cut Automix data
when it occurs just a bit later than you want it to, or when you need to re-align it with
audio you've moved forward in the project.
ERASE
Automix ERASE cleans out Automix events between the IN and OUT points. This can
be useful when you've recorded parameter value changes you decide you don't want,
preferring to let an earlier parameter value remain in place until the OUT point.
Roland VS-2480 Owner's Manual
IN OUT TO
Before
What it does:
sets the location of the Automix data region's time anchor
sets the destination location for the time anchor
IN OUT
Before
IN OUT
Before
IN OUT
Before
IN OUT TO
After
IN OUT
After
IN OUT
After
IN OUT
After
www.rolandus.com
26—Automix
FROM is set to
the same
location as IN.
335