Safety Warnings - Mitel TA7102 Installation Manual

5.3

SAFETY WARNINGS


This section lists the following safety warnings:

Circuit Breaker (20A) Warning

TN Power Warning

Product Disposal Warning

No. 26 AWG Warning

WAN, LAN, Phone-Fax 1 and Phone-Fax 2 Connectors Warning

Socket Outlet Warning
Circuit Breaker (20A) Warning
Warning: This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure
that a fuse or circuit breaker no larger than 120 VAC, 20A U.S. (240 VAC, 10A international) is used on
the
phase conductors (all current-carrying conductors).
TN Power Warning
Warning: The device is designed to work with TN power systems.
Product Disposal Warning
Warning: Ultimate disposal of this product should be handled according to all national laws and
regulations.
No. 26 AWG Warning
Warning: To reduce the risk of fire, use only No. 26 AWG or larger telecommunication line cord.
WAN, LAN, Phone-Fax 1 and Phone-Fax 2 Connectors Warning
Warning: Do not connect the WAN, LAN, Phone-Fax 1 and Phone-Fax 2 connectors directly to the
Public Switched Telephone Network (PSTN), to an off premise application, an out of plant application,
any exposed plant application, or to any equipment other than the intended application, connection may
result in a safety hazard, and/or defective operation and/or equipment damage. Exposed plant means
where any portion of the circuit is subject to accidental contact with electric lighting or power conductors
operating at a voltage exceeding 300V between conductors or is subject to lightning strikes.
153/1531-ANF 901 14 2017-03-08
TA7102 Hardware Installation
35