Mitel TA7102 Installation Manual page 28

Table 7: RESET/DEFAULT Button Interaction
RESET/ DEFAULT
Button Pressed for:
2 to 6 seconds
7 to 11 seconds
12 to 16 seconds
17 seconds and more
At Start-Time
You can use the RESET/DEFAULT button at start-time – you power the unit off, and then depress the
button until the LEDs stop blinking and remain ON. This applies the "Factory Reset" procedure (see
Factory Reset). This feature reverts the TA7102 back to its default factory settings.
153/1531-ANF 901 14 B 2017-03-08
Action Comments
Restarts the
TA7102
Sets the TA7102
in Partial
Reset Mode
Restarts the
TA7102 in Factory
Reset
No action is taken
No changes are made to the
TA7102 settings.
Sets some of the TA7012
configuration to pre-
determined values.
Deletes the persistent
configuration, creates a new
configuration file with the
default factory values, and
then restarts the unit.
The RESET/DEFAULT
Button
Pressed event is ignored
TA7102 Hardware Installation
LEDs Pattern
Power LED:
• blinking, 1Hz,
50% duty
All other LEDs:
• OFF
All LEDs
•
blinking, 1Hz,
50% duty
All LEDs
•
steady ON
N/A
28