Reset/Default Button - Mitel TA7102 Installation Manual

LED Patterns – Default Behaviour
When no specific condition matches those described in Table 5, the LEDs behave individually according
to the following rules:
Table 6: Default LED Behaviour
LED Type
Power
ETH
In Use
Ready
4.3

RESET/DEFAULT BUTTON

The RESET/DEFAULT button allows you to:

Cancel an action that was started.

Revert to known factory settings if the TA7102 refuses to work properly for any reason or the
connection to the network is lost.

Reconfigure a unit.
At Run-Time
The RESET/DEFAULT button can be used at run-time – you can press the button while the TA7102
is running without powering the unit off. Table 7 describes the actions you can perform in this case.
153/1531-ANF 901 14 B 2017-03-08
Condition
RestartInProgress
RestartCompleted
Network traffic
No network traffic
Lines Idle and Unlocked
Lines InUse and Unlocked
Shutting Down
Locked
All lines are enabled
(operational state).
All lines are disabled
(operational state).
At least one line is enabled
and at least one line is
disabled (operational
state).
TA7102 Hardware Installation
Behaviour
Blinking, 1 Hz, 50% duty
Steady ON
Blinking, variable rate
Steady ON
Steady OFF
Steady ON
Steady yellow
Blinking yellow, 1 Hz, 50% duty
Steady ON
Steady OFF
Blink 0.25 Hz 75%
27