Indicators (Leds) - Mitel TA7102 Installation Manual

4.2

INDICATORS (LEDS)

The indicators (LEDs) of the TA7102 are described in TA7102 Connectors and Indicators.
LED Patterns – Specific Conditions
Table 5 describes the different states a Mitel unit can have and their associated LED patterns.
Table 5: LED Patterns
CondiCondition
RestartPending
RecoveryPending
DefaultSettingsPendin g
UpdateInProgress
153/1531-ANF 901 14 B 2017-03-08
Description
Triggered when the RESET/DEFAULT
button is pressed in the ResetPending
state. The unit prepares for a physical
shutdown and restart.
Triggered when the RESET/DEFAULT
button is pressed at start-time or for at
least 7 seconds.
Triggered when the RESET/DEFAULT
button is not released while in
ResetPending state.
At run time, if the RESET/DEFAULT
button is released within 5 seconds, the
unit applies default settings, otherwise
the action is cancelled and the unit goes
back to the operation mode state or it
resets.
At start time, the unit stays in this state
until the RESET/DEFAULT button is
released. The unit then applies the
default settings and restarts.
A firmware pack is downloaded into the
unit and written to persistent storage.
TA7102 Hardware Installation
LED Pattern
Power LED:
•
blinking, 1Hz, 50%
duty
All other LEDs:
•
OFF
All LEDs:
•
blinking, 1Hz, 50%
duty
All LEDs:
•
steady ON
All LEDs:
•
cycling from left to
right, individually blinking
1Hz, 33% duty
25