Mitel TA7102 Installation Manual page 26

UpdateFailed
Rescue Network
Enabled
BootOnRecoveryBank
Automatic network
configuration in progress
No network address set
NetworkRescue
153/1531-ANF 901 14 B 2017-03-08
Triggered after a failure of a firmware
pack download operation. After 4
seconds, the unit restarts.
Triggered after the user has performed a
partial reset procedure.
Triggered when the unit is booting on the
recovery bank and no update is pending.
Waiting for DHCP (IPv4 or IPv6) answer
or IPv6 router advertisement or PPPoE
connection.
Triggered when the unit cannot be
contacted because DHCP failed, PPP
failed, and no static interface is
configured.
The unit tries to download and install a
firmware given by the Network Rescue
server.
TA7102 Hardware Installation
All LEDs:
•
blinking at 3Hz,
•
50% duty. One LED out
of two has a 180 degree
phase. This pattern lasts
for 8 seconds.
Power and In Use LEDs:
•
blinking
(synchronized)
1Hz, 75% duty
Power LED:
•
blinking, 0.25Hz,
75% duty
All LEDs:
•
Blinking green,
3Hz, 50% duty
Power LED:
•
blinking, 3 Hz, 50%
duty.
Ready LED:
• Off
All other LEDs:
• blinking to show a LED
displacing light from left to
right and right to left.
26