User Menu - AERMEC MODUCONTROL Usage Manual

To access the USER menu, press the
key in (Fig.7). Once the key has been
pressed, you must insert the password
to access the various menus; to access
the user menu, the password is 000 (di-
splayed by default). To modify the value
of the passwords, use the arrow keys.
When you have inserted the correct
PASSWORD = 000
Setting operational parameters (user level)
MIN
Index - String
value
j j
MIN
Index - String
value
-20°C
j j
j Parameters only visible in heat pump models
Parameters only visible in models set for
hot domestic water production
48
GB
6343841_00 / Ver - 4.20

USER menu

password, press the key in (Fig.7). The
monitor will show the index of the USER
parameter and a 3-character string that
identifi es it; the string will be displayed
for one second, after which it is repla-
ced by the value of the parameter itself.
To move on to the next parameter, use
the arrow keys (Fig.8). To modify a pa-
Fig.7
Setting of operational mode (HOT/COLD)
MAX
value
This parameter identifies the functioning mode set for the unit:
• set value = 0 - Cooling mode;
• set value = 1 - Heating mode.
0 1
In cooling only units, this parameter is displayed but it cannot be modified.
In software versions prior to 3.75, to make the season change the unit must be in
standby.
Setting of cooling temperature
MAX
value
26°C This parameter indicates the value of the work setting active in cooling mode.
rameter, just select it, press the key in
(Fig.7), modify the assigned value using
the arrow keys in (Fig.8), and confi rm
the modifi cation by pressing the key in
(Fig.7) again.
R
Fig.8
Parameter function
Parameter function
j j
j
Parameters only visible in the models with DCP installed
Parameters only visible in bicompressor models
Parameters only visible in the models with inverter compressor
R