Advertisement
2. TURNABLE ENTRY UNIT only with T9090
The diameter of the cable hole should be minimum 9 mm, maximum 12 mm. The hole must be
deburred well to avoid damage to the cable.
Connect the cable to the lock at the "ENT" position and mount the lock.
Connect one (1) battery to the battery clip. Only use 9V ALKALINE Duracell Procell- or Energizer
batteries.
M-LOCKS BV
Vlijtstraat 40
NL-7005 BN Doetinchem
Prepare the mounting and cable holes according to picture
-
Hold the bearing plate in a way against the mounting
surface that "UP" is readable on top.
-
Affix the plate with the two mounting adapter screws (M4),
hand tied.
-
Drill (3,5 mm) the screw heads so that tools don't work for
dismounting (due to EN1300)
Insert first the spring and pin into the hole on the back cover
Insert the grooved shaft all the way into the entry housing
Route the cable through the cable hole
Hold the unit at the (approximately) 10:00 o'clock position and
slide it on the mounting adapters.
Turn unit clockwise until it clicks into a
stationary position at 12:00.
Remove adhesive film from pad and line
up margins carefully, before fixing it.
ver. 1.2 2011 10 21
2
T6530
Tel: +31 (0)314 376 876
Fax: +31 (0)314 376 878
www.m-locks.com
Advertisement
