Roland V-Synth GT Owner's Manual page 72

Patch Mode (Editing a Patch)
Pattern Input Area
Value
0, 32, 64, 96, 127,
Tie/Clr
Grid
End Point
Clear
Real Rec
(Realtime Recording)
Step Rec
(Step Recording)
72
This area is where you input or edit notes or control changes. The symbols have the follow-
ing meaning:
●: Note
=: Tie
❍: Control change
Shows the velocity of the note or the value of the control change selected in the pattern input
area.
When inputting notes: When you touch one of these buttons, a note with the velocity shown
on that button will be input at the cursor location within the pattern input area. When you
touch <Tie>, a tie will be input at the cursor location.
When inputting control changes: A control change with the value shown on that button will
be input at the cursor location within the pattern input area. When you touch <Clr>, the
selected control change will be erased.
When you are editing, these buttons modify the velocity of the note that is selected in the
pattern input area, or the value of the control change.
You can also input the note velocity or control change value by using the VALUE dial or
[INC/+] [DEC/-].
Specifies the note value that will correspond to "one step" of the arpeggio pattern.
(Quarter note), (Eighth note),
(Sixteenth note), (Dotted sixteenth note),
Specifies the pattern length as a number of steps (1–32).
Erases the pattern data (p. 75).
Uses realtime recording to create a pattern (p. 73).
Uses step recording to create a pattern (p. 74).
(Dotted eighth note),
(Thirty-second note)