Quick Reference Installation Steps; General Requirements; Procedures; Figure 1-2 Quick Reference Installation Procedures - Siemens SIMATIC TI505 User Manual

1.2

Quick Reference Installation Steps

General
Requirements

Procedures

1-4 Installation and Set-up
In order to install and use the MODNIM module correctly, you must meet
the following requirements.
Ensure that you have the appropriate MODNIM model.
The communications configurations of all devices attached to the
network must match; i.e., they must all have the same baud rate, stop
bits, parity, handshaking, and transmission mode (ASCII or RTU).
Figure 1-2 provides a quick reference list of the basic steps for installing the
MODNIM.
Insert module into selected I/O slot (Series 505) or two adjacent slots (Series 500).

Figure 1-2 Quick Reference Installation Procedures

Install power and I/O cabling.
Disconnect power to the I/O base.
Set configuration dipswitches.
Power up the I/O base.
Check MODNIM indicator lights.
Verify MODNIM is logged into PLC.
Connect network cables.
SIMATIC TI505/TI500 MODNIM User Manual