SIMATIC TI505/TI500 MODNIM User Manual
Once the I/O slot keys are in place, you can insert the module as follows.
1.
Set the dipswitches, described in Section 1.3.
2.
Position the module so that the front bezel is facing you.
3.
Hold the top and bottom of the bezel and carefully slide the module into
the slot, pushing it all the way into the base connector. When the
module is fully seated in the I/O base, locking tabs will hold the module
in place. (See Figure 1-10.)
Locking tabs
Figure 1-10 Installing the Series 500 MODNIM in the I/O Base
4.
To remove the module, pull the tabs away from the module and slide it
out of the base, being careful not to damage the edge card.
Locking tabs
Installation and Set-up
1-13