Grizzly G0462 Owner's Manual page 38

Turning
Symptom Possible Cause
Bad surface finish. 1. Wrong spindle speed.
2. Dull chisel or wrong chisel being used for
the operation.
Inaccurate turning 1. Headstock and tailstock are not properly
results from one end
aligned with each other.
of the workpiece to
the other.
Can't remove 1. Quill has not retracted all the way back into
tapered tool from
the tailstock.
quill.
2. Debris was not removed from taper before
inserting into quill.
Quill will not 1. Keyway not aligned with the quill lock lever. 1. Align the quill keyway with the quill lock lever as
move forward into
workpiece when
handwheel is
turned.
-36-
Possible Solution
1. Use trial-and-error to find a better spindle speed.
2. Sharpen chisel or try a different chisel.
1. Realign the tailstock to the headstock (Page 37).
1. Turn the quill handwheel until it forces taper out of
quill.
2. Always make sure that taper surfaces are clean.
shown in Figure 12, on Page 16 and slightly tighten
the lever to engage the keyway.
G0462 Wood Lathe (Mfd. Since 11/14)