Table of Contents
Advertisement
To make the settings as described in this chapter, the inverter must be powered with alternating current (mains grid).
The inverter also needs a DC voltage in order to operate fully from the energy provider.
S e l e c t l a n g u a g e
E n g l i s h
D e u t s c h
F r a n ç a i s
F R A - I s 6 0 H Z
U K G 5 9 - 3 2 3 0
F R A - I s 5 0 H Z
F R A - I s 6 0 H Z
F R A N C E M V
A r e y o u s u r e t o
s e t c o u n t r y :
U K G 5 9 - 3 2 3 0
Y e s / N o
D e l t a p r o t .
S U N S P E C p r o t .
A r e y o u s u r e t o
s e t p r o t o c o l l :
S U N S P E C p r o t .
Y e s / N o
S e t t i n g I D :
I D = 0 0 1
A r e y o u s u r e t o s e t
I D :
1
Y e s / N o
1 0 . F e b 2 0 1 7 1 5 : 3 2
S t a t u s :
O n G r i d
P o w e r :
E - T o d a y :
Quick Installation Guide for Solar Power Inverter M88H EU V3 EN 5013240202 02 2018-03-22
1.
Use the
button.
ENT
2.
Use the
the
ENT
3.
Check that the correct country or mains type is selected.
If the correct country is selected, use the
entry and the press the
To change the selection, press the
NOTICE
The Delta protocol is the Delta Modbus protocol and is intended for utilization with the
Delta Service Software.
4.
Use the
then press the
5.
Check that the correct protocol is selected.
If the protocol is selected, use the
then press the
Press the
NOTICE
If multiple inverters are connected to the PV system then a different inverter ID must set for
each inverter. For example, the inverter ID is used by monitoring systems to uniquely iden-
tify each inverter.
6.
Use the
button.
7.
Check that the correct inverter ID is set.
If the correct inverter ID is selected, use the
entry and the press the
Press the
þ
The basic settings are now complete. The standard menu is displayed.
→ The inverter starts a self-test lasting approx. 2 minutes. The remaining time is
shown on the display.
0 W
0 k W h
Commissioning – basic settings
and
buttons to select the English language and then press the
and
buttons to select your country or mains type and then press
button.
button.
ENT
EXIT
and
buttons to select SUNSPEC as RS485 protocol option and
button.
ENT
button.
ENT
button to change the selection
EXIT
and
buttons to set the individual digits and then press the
button.
ENT
button to change the selection
EXIT
and
buttons to select the Yes
button.
buttons to select the Yes entry and
and
and
buttons to select the Yes
ENT
49
Advertisement
Table of Contents
