MPR-e
this type of MPT-HC V2/MPT-XP is identified by two Logistical Items, one for the
EXTERNAL DIPLEXER assembly and another for the RF TRANSCEIVER
assembly. To read the EXTERNAL DIPLEXER assembly identification label, it is
necessary to separate the EXTERNAL DIPLEXER assembly from the RF
TRANSCEIVER assembly.
The MPT-HC V2/MPT-XP/9558HC consists of the following subcomponents:
•
MPT-CB: Common Belt sub-component. This section is frequency-independent,
and all the features relevant to this unit are common to all the MPT RF options.
•
MPT-RF: Radio Frequency section that is frequency-dependent.
The MPT-HC V2/MPT-XP/9558HC interface is based on Gigabit Ethernet, that can be either
optical or electrical depending on the needs and the cable length. If the optical port must be
used (data and/or RPS port), the corresponding SFP plug-in must be installed.
Figure 39: MPT-HC V2/MPT-XP/9558HC housing
Product information and planning
Figure 38: MPT system
139