Maintaining; Managing The Power Supply - MobileDemand T1150 User Manual

MobileDemand is not responsible for unusual operation, maintenance, or unforeseen conditions that lead to data loss
or destruction of the unit.
• Use the original battery to avoid possible explosions.
• Avoid extreme shock, such as dropping the xTablet T1550 from extreme heights.
• Do not operate the T1150 in extreme temperatures. Only operate the unit in temperatures ranging from 14°F
to +122°F (-10°C to +50°C) and only store the unit in temperatures from -4°F to +140°F (-20°C to +60°C).
• Avoid wet or dirty surroundings and minimize any exposure to direct sun.
• Stay away from environments with high magnetic or electrical discharge.
• If the T1150 submerged under water, immediately check the interface after letting it dry thoroughly.
• Do not use any harsh chemical composition cleaners to wipe the unit.
• Avoid any corrosion and humidity damage.
• If you need to clean the T1150, use a dry soft cloth or a tissue wipe. You can use mild liquid cleansers such as
Windex or Formula 409. Avoid getting liquid into connectors.
• Back up your data on a regular basis.
• Do not dismantle the T1150 or you may risk losing coverage via the MobileDemand warranty.
• MobileDemand does support the use of products from the 3G Dongle brand. Representatives from 3GDongle
may advise you on other products, which you can purchase and use for testing purposes.
When using the xTablet T1150, please refer to the following illustrations for proper use.

Managing the Power Supply

Use basic safety precautions when using an AC/DC adapter and battery power. Make sure your T1150 is connected to
an AC power source via the AC adapter before you turn it on for the first time. If the T1150 powers down because of
low battery power, it could cause a system failure. Note the following do's and don'ts of an AC/DC adapter:
Do
• Use the adapter that came with the T1150
• Be aware of heat coming from the AC/DC adapter when it's in use
Don't
• Leave the AC power cord plugged in after you power down the T1150 if you plan to leave it unused for longer
than a few days or months.
To attach the T1150 to a power source
• Plug the DC end of the adapter into the DC-in jack on the T1150.
• Plug the adapter into the power outlet.
• When done charging, remove the adapter plug from the wall, then the DC connector from the T1150.
Charging the T1150 via an AC adapter.

MAINTAINING

9