Pelpro PP130 Owner's Manual page 27

Troubleshooting
Symptom
Igniter does not Igniter short circuit. The fuse will be blown and
turn off upon replacement of the fuse, the igniter will
remain on when Stove has power.
Feed motor does
Feed motor short circuit. The fuse will be blown
not shut off and upon replacement of the fuse, the feed motor
will remain on when Stove has power.
Stove fails to shut Stove running in maximum or minimum
off.
Large, lazy flame, Dirty Stove.
orange color.
Poor fuel quality, high ash content.
Black ash on
glass.
Incorrect air-fuel adjustment
Excessive feeding/Feed Motor locked on
Excessive fuel Excessive feeding/Feed Motor locked on
spilling over the
fire pot into the
ash wells and/or
excessive flame
pelprostoves.com
Possible Cause
PelPro Pellet Stove • 7086-171O • 2/20/18
Corrective Action
Inspect wires, blowers, and power cord to find
cause of short circuit. Replace board and failed
component.
Open hopper to stop the feed motor.
Inspect wires feed motor, control board, and power
cord to find source of short circuit. Replace control
board and failed component.
Turn dial control to Off position. See Also, "Feed
Motor Does Not Shut Off".
The Stove should go into a shutdown.
Clean Stove, including fire pot and venting system.
Clean exhaust path. Try a different brand of pellets.
Turn fuel adjustment trim dial to COUNTERCLOCK-
WISE to increase combustion air speed; see trim
pot adjustment section.
Follow corrective action for feed motor does not turn
off symptom.
Follow corrective action for feed motor does not turn
off.
27