Pelpro PP130 Owner's Manual page 12

Installing Your Stove
• 5 Install pellet venting through wall and connect vent/pipe to
Stove
A
• Some venting manufacturers offer pellet Stove adapters
for their venting for easier installation
• Seal all pipe joints using high-temp silicone (500°+)
• Secure exhaust venting system to the Stove with at least
3 screws or rivets per the pipe manufacturer's instructions.
Also secure all connector pipe joints with at least 3 screws
through each joint.
• Install termination cap
• Confirm all required Stove clearances to combustibles
Pro Tip
Installing a clean-out "T" (sold separately) to the rear
of your Stove, when venting vertically can save time during cleaning.
6 Install outside air kit (included)
For optimal performance, PelPro recommends the
outside air kit for all installations. Outside air kit is
required for all mobile/manufactured home installations.
Install through wall
• Maintain clearances from exhaust
• Remove knock out in the rear of Stove
- Attach flex pipe to outside air connection
on Stove
- Use hose clamp
- Route tube outside the structure
- Attach cap
- Secure to outside wall with appropriate fasteners
Take a Break
Inspect your work:
_____ Confirm clearances to combustibles are maintained
_____ Pipe joints are secure and properly sealed
_____ Outside air kit installed properly
_____ Confirm termination clearances
12
B
PelPro Pellet Stove • 7086-171O • 2/20/18
A
B
CAUTION!
Never draw outside
combustion air from:
• Wall, floor or ceiling cavity
• Enclosed space such as an
attic, garage or crawl space.
pelprostoves.com