Key To Figure A2 (Display); Key To Figure A3 (Accessories) - GE druck dpi 104 User Manual

Key to figure A2
(Display)
Key to figure A3
(Accessories)
4
To Start
Item Description
11. 5-digit main display.
12. 2.5-digit percentage indicator (0-100% FSO).
%FSO = [applied pressure/(FSOHigh—FSOLow)] * 100
13. 20 segment analog dial in increments of 5% FSO (large division
marks = 10% increments).
%FSO = [applied pressure/(FSOHigh—FSOLow)] * 100
14.
The units of measurement: kPa, MPa, kg/cm
mmHg, mmH
15. Mode indication.
Voltage output (Vout) mode - On.
RS232 connection. The data transmit/receive function is active.
Switch mode - On. To monitor an external pressure switch.
= switch closed
Menu Lock mode - On. To restrict access to the menu functions.
Alarm mode - On. The symbol flashes when the measured value
satisfies one of the alarm conditions.
= High alarm
Maximum/minimum mode - On.
IDOS UPM mode - On. To monitor pressure from a UPM
16. Low battery power indication: Battery life ≤ 15%.
Table 3: (Part of Table) Key to figure A3
Option Description
(A) Part No. IA4090-1-V0: DPI 104 to PC RS232 cable (8-pin to 9-pin
D-type connector). To transmit data to a PC for applicable
monitor and control software (accessory D).
(B) Part No. IA4101-1-V0: DPI 104 to UPM cable assembly. The
assembly has these connections:
UPM cable + 5-pin connector: To give an IDOS UPM a 3 V power
supply and an RS232 connection to the DPI 104 - Figure B2 (d).
GND: Ground connection.
V-OUT: To supply a voltage output (Vo) - Figure B2 (c).
ALARM: To supply an alarm output - Figure B2 (b).
SWITCH: To monitor an external switch - Figure B2 (a).
12V: 12V input for accessory C - Figure B2.
Note: The assembly can supply 12 V to the DPI 104 and 3 V to the
IDOS UPM.
(C) Part No. 191-129: Universal 12V power supply for accessory B.
Part No. 1S-SICALPRO-DPI104: SiCal PRO monitor and control
(D)
software. This includes accessory A.
Table 2: Key to figure A2
O, mH O, inH O, inHg.
2 2 2
2
, psi, mbar, bar,
= switch open
= Low alarm
K0394 Issue 3 - [EN] English