GE druck dpi 104 User Manual page 8

Page 5
Menu Description
C _ _ _ _ = Calibration: To continue, set
the correct calibration
access code = last four digits
of S/N. *******
= Set low/high alarm:
A OFF
Set to On or OFF.
= Supply voltage output
OFF
(Vout):
Set to OFF, P-V, or US.
= Set Vout scale factor: A
S 1.00
Vout adjustment.
= Set automatic power OFF:
Au On
Set to On or OFF.
= Set lock code: A menu
L OFF
protection facility. Set to On
or OFF.
= Set scan rate: A rate that
Sc 02
the DPI 104 uses to take
pressure samples.
= Monitor external IDOS: Set
OFF
to On or OFF.
= Set FSO low register: To set
FS ↓
a different range for these
functions: analog display, %,
alarm.
= Set FSO high register: To set
FS ↑
a different range for these
functions: analog display, %,
alarm.
Normal display
6
To Start
Steps Result/Subsequent steps
1 2
C0 (correct the zero offset value) ➤
C2 (do a two-point pressure calibration) ➤
V2 (do a two-point voltage calibration), refer to
menu operations.
On ➤ 000.0 ↓ ➤ 100.0 ↑
Set a value for the low and/or high alarm (0 to
105% FSO).
P-V: Vout is proportional to the pressure value on
the display. Make sure the Vout scale factor is
correct.
US ➤ 000.0: Set a Vout value (0 to 100%) to control
an external pressure regulator. Make sure the
Vout scale factor is correct.
If applicable, set a new Vout scale factor (0.01 to
9.99), factory value = 1.00.
On ➤ Au 15 : Set the period for automatic power
OFF (1 to 99 minutes), factory value = 15 minutes.
On ➤ L 000 : Set a new lock code (if necessary),
factory code = 000.
Set an applicable rate (02 to 10 Hz),
factory value = 02 Hz.
Monitor function is set on or off.
Set a value for the low end of the range (refer to
Table 8, page 16).
Factory value = Factory calibration value.
Set a value for the high end of the range (refer to
Table 8, page 16).
Factory value = Factory calibration value.
K0394 Issue 3 - [EN] English