Menu: Monitor Maximum/Minimum; Menu: Monitor A Pressure Switch - GE druck dpi 104 User Manual

Menu: Monitor
maximum/minimum
Maximum/minimum -
Set-up and use
Menu: Monitor a
pressure switch
Pressure switch input -
Set-up and use
[EN] English - K0394 Issue 3
Use this function to monitor the maximum and minimum pressure.
It uses the specified scan rate (refer to menu operation, page 5).
Recommendation
To save battery power use an external power supply.
Menu: Set function to On (refer to menu operation, page 5).To save
battery power use an external power supply.
When function is On, use steps 1 & 2 to show the
maximum/minimum since the last reset.
1 maximum
Step 3 resets the values for maximum/minimum, press and hold.
Use this function to measure the performance of a pressure switch
(mechanical operation and hysteresis). It uses the specified scan
rate (refer to menu operation, page 5).
Recommendation
To save battery power use an external power supply.
1. Connect the DPI 104 with the applicable Table 3 accessories,
page 4:
Accessories B/C - refer to cover, Figure B2 (a).
Accessory E - refer to Figure 2, below/Table 6, page 8.
2. Menu: Set function to On (refer to menu operation, page 5).
Figure 2: Example configuration - Switch input
These examples (Figure B2 (a)/, above) show the display when the
switch condition changes (open or closed). The analog dial and the
% indication continue to monitor the normal pressure.
2 minimum 3
Reset
Pin 1 (+), 2 (GND)
Pin 7 (Switch)
Pin 2 (GND)
donE
12-24 Vdc
Operation
11