External Power; Operation; Menu: Set Units; Menu: Set Tare (Or Set Zero) - GE druck dpi 104 User Manual

External power

Operation

Menu: Set units

Units - Set-up
Menu: Set tare (or set
zero)
Test Equipment Depot - 800.517.8431 99
[EN] English - K0394 Issue 3
Table 3, page 4 gives the optional accessories that use the
connector.
Note: Use only original parts supplied by the manufacturer.
The RS232 interface makes a serial network of units (maximum: 99).
Refer to menu operation, page 5.
Recommendation
For the following functions and operations use an external power
supply :
• Functions: Maximum/minimum, Switch, Low/high alarm, Vout,
IDOS
• Operations that use the DPI 104 for long periods.
This section shows how to use the DPI 104.
There are 11 different units to measure pressure, refer to the menu
operation, page 5.
Refer to Safety Instructions and User Guide, publication K0387.
Use the tare function to adjust the pressure value on the display,
refer to Table 7, below.
Range
g: 0.7 bar (10 psi)
a, sg, g: ≥ 2 bar (30 psi)
If a value is set that is not in the permitted range, the value goes
back to the last accepted value.
Washington Street, Melrose, MA 02176
TestEquipmentDepot.com
Table 7: Permitted tare values
Permitted tare values
-0.7 bar (-10 psi) to 105% FS
-1 bar (-15 psi) to 105% FS
9
Operation