Ethernet Port - Pro-face PFXGP4502WADW Hardware Manual

Ethernet Port

Introduction
The GP-4402WW/GP-4502WW is equipped with an IEEE802.3 compliant Ethernet
communication port that transmits and receives data at 10 Mbps or 100 Mbps.
NOTE:
Ethernet networks must be installed by a trained and qualified person.

One to one (1:1) connections must be made with a hub or a switch. You can use the 1:1

connection with a cross cable depending on the connected PCs and network cards.
Characteristics
The table describes the different Ethernet characteristics:
Characteristics
Connector type
Driver
Cable type
Automatic cross-over
detection
Pin Assignment
The figure shows the RJ45 Ethernet connector pin assignment:
The table describes the RJ45 Ethernet connector pins:
Pin Signal
1 TD+
2 TD-
3 RD+
4 –
5 –
6 RD-
7 –
8 –
NOTE: The GP-4402WW/GP-4502WW supports the MDI/MDIX auto-crossover cable function.
You do not have to use special Ethernet crossover cables to connect devices directly to this port
(connections without an Ethernet hub or switch).
Description
RJ45
10 M half duplex (auto negotiation)

100 M full duplex (auto negotiation)

Shielded
Yes
GP-4402WW/GP-4502WW Hardware Manual
33