Keypad And Status; Keypad; Removing And Replacing The Keypad - Emerson Digistart IS1x0043B series User Manual

Safety Rating Mechanical
Information Data Installation
5.

Keypad and Status

5.1

Keypad

Figure 5-1 Keypad and display
2 min
1
2
Ready Ready
Run Run
Stop Stop Start Start
3
4
Trip Trip
5
Table 5-1 Feedback LEDs
LED On
Ready Ready
Run Running
Trip Starter tripped
Local Local control mode
5.2

Removing and replacing the keypad

The keypad can be removed from the soft starter and mounted remotely on a panel using the remote mounting kit.
The keypad stores a backup copy of the parameters in the soft starter, so one keypad can be used to program multiple Digistart IS
starters.
The keypad can be removed or replaced while the starter is running. It is not necessary to remove mains or control
NOTE
voltage.
It is the installer's responsibility to ensure that any enclosure which allows access to models IS2x0145B to IS4x1000B
and IS3x0255N to IS561600N while the product is energized, provides protection against contact and ingress
requirements of IP20.
WARNING
5.2.1 Removing the keypad
The keypad is attached to the body of the soft starter by a DB9 serial connector and two screws. The screws are concealed behind
a snap-on faceplate.
To remove the keypad:
1. Models IS1x0023B to IS4x1000B: open the Digistart IS's door.
Models IS3x0255N to IS561600N: remove the Digistart IS's front cover.
2. Insert a small screwdriver under the faceplate, at the base of the keypad, and use the screwdriver to lever the faceplate off
the keypad.
3. Lift the faceplate off completely.
4. Remove the two screws holding the keypad in place.
5. Lift the keypad gently off the soft starter. Pull the keypad forwards, to avoid damaging the DB9 connector.
32
Electrical Keypad Quick Start
Installation and Commissioning
Status
Four-line display for status and programming details.
Status LEDs
Soft starter local control buttons.
Menu navigation buttons.
M: Enter a menu or parameter, or save a parameter change.
: Exit the menu or parameter, or cancel a parameter change.
change the setting of the current parameter.
Shortcut buttons for quick access to common tasks.
Local Local
LCL
RMT
08349.A
Restart delay or motor temperature check
or DI4 not closed (default setting)
Starting/ stopping
Warning
n/a
www.controltechniques.com
Operation Programming Diagnostics Application
: Scroll to the next or previous status screen, menu or parameter, or
Blinking
Technical Maintenance Options
Examples Data
Off
No control power
Not running, starting or stopping
Normal operation
Remote control mode
Digistart IS User Guide
Issue: 4