Jacobsen HR9016 Mounting Instructions page 9

fuel tank to frame. Remove two remaining 5/16" screws (M) holding fender wall to
frame and remove fender wall. Lift fuel tank out and away from tractor. Note - Be
careful not to damage fittings.
Figure Two
——————————————————————————————————
Remove seat. Remove three 5/16" screws, lockwasher and washers (N) holding
heat shield to hydraulic tank, and remove shield. Remove four 7/16" truss head
screws (P) holding floor board to frame. Remove floorboard. Remove four 3/8"
screws and corresponding hardware (R) holding seat pan to frame. Disconnect
wire harnesses from seat. Remove seat and seat pan assembly from tractor.
Figure Three
——————————————————————————————————
Loosen hydraulic tank. Remove four 5/16" screws and corresponding hardware
(S) securing right fender to frame. Remove fender. Remove front clamp and
loosen rear clamp holding 2" pump suction line in place. Loosen front 5/16"
hardware, and remove rear 5/16" hardware (U) holding fender wall to frame.
Loosen front 1/2" carriage bolt (X), and remove rear 1/2" carriage bolt (V)
securing hydraulic tank to frame. Caution – Hydraulic tank is full of oil. Do not
9