Fault Table - Siemens SN series Instruction Manual

Fault table

Fault
"Check water supply"
display lights up.
Fault code ":‹ˆ is lit.
Fault code ":‚ƒ is lit.
Fault code ":‚... is lit.
Fault code ":‚† is lit.
Fault code ":‚‡ is lit.
Fault code ":ƒƒ is lit.
* Depending on the features of your dishwasher
Reason
Supply hose kinked.
Tap turned off.
Tap jammed or calcified.
Filter in the water supply blocked. Switch off the appliance and pull out the
Intake opening (on right inside of
appliance) covered by dishes.
Heating element calcified or
soiled.
Water protection active.
Constant water supply.
Filters 1j are soiled or
blocked.
Fault, what to do? en
Solution
Install supply hose without kinks.
Turn on the tap.
Turn on the tap.
Flow rate must be at least 10 l/min when
water supply is open.
mains plug. Turn off water supply.
Unscrew water connection.
Clean filter in the supply hose. Screw
water connection on again. Check for
leaks. Reconnect power supply. Switch on
the appliance.
Arrange dishes so that the intake opening
is not obstructed.
Clean appliance with dishwasher cleaning
agent or descaler. Operate the dishwasher
with water softening system and check the
setting.~ " Water softening
system/special salt" on page 20
Turn off tap.
Call customer service and quote the fault
code.
Clean filters. ~ "Filters" on page 41
43