Table of Contents
Advertisement
aus
Fault, what to do?
Fault table
Fault
"Check water supply"
display X lights up.
Error code ":‹ˆ is lit.
Error code ":‚ƒ is lit.
Fault code ":‚... is lit.
Fault code ":‚† is lit.
Fault code ":‚‡ is lit.
Error code ":ƒƒ is lit.
Error code ":ƒ... is lit.
Error code ":Ġ is lit.
28
Cause
Supply hose kinked.
Tap turned off.
Tap jammed or calcified.
Filter in the water supply blocked. Switch off the appliance and pull out
Intake opening (on right inside of
appliance) covered by utensils.
Heating element soiled.
Water protection system
activated.
Constant water inflow.
Filters 1J are soiled or
blocked.
Waste water hose
is blocked or kinked.
Siphon connection still sealed.
Cover on the waste water pump
loose.
Waste water pump blocked
or cover on the waste water
pump is not locked in position.
Remedial action
Install supply hose without kinks.
Turn on the tap.
Turn on the tap.
Flow rate must be min. 10 l/min.
when water supply is open.
the mains plug. Turn off the tap. Unscrew
water connection.
Clean filter in the supply hose. Screw water
connection on again. Check for leaks.
Reconnect power supply. Switch on
the appliance.
Arrange utensils so that the intake opening
is not obstructed.
Clean appliance with dishwasher cleaning
agent.
Turn off tap.
Call customer service and mention the fault
code.
Clean filters.
(See Cleaning and maintenance)
Install hose without kinks, remove any
residue.
Check connection to siphon and open if
required.
Lock cover correctly.
(See Waste water pump)
Clean pump and lock cover correctly. (See
Waste water pump)
Advertisement
Table of Contents
