Adjusting The Water Softening System; Using Special Salt; Detergent With A Salt Component; Switching Off Water Softening Unit - Siemens SN series Instruction Manual

Hide thumbs Also See for SN series:
Table of Contents

Advertisement

Adjusting the water softening
system
You can set the amount of salt that
should be added to a value between
•:‹‹ and •:‹ˆ. No salt is needed with
the setting •:‹‹.
Here's how to set up the amount of
added salt:
Ask your local water utility company
1.
for the water hardness value of the
tap water.
Required setting can be found in the
2.
water hardness table.
Switch on ON/OFF switch (.
3.
Press and hold the ‹ button
4.
for 3 seconds.
In the display window @ you will
see the factory setting •:‹... and '. .
Adjust the setting using the buttons -
5.
and + P.
Press and hold the ‹ button
6.
for 3 seconds.
The chosen setting has now been
stored in your dishwasher.

Using special salt

Top up the special salt as soon as the
salt refill indicator ): lights up in the
control panel. Always top up the special
salt immediately before switching on the
dishwasher. This ensures that overrun
special salt solution is immediately
rinsed out and that corrosion in the
washing tank cannot occur.
Caution!
Detergent will destroy the water
softening unit! Never pour detergent into
the dispenser for special salt.
Water softening system/special salt en
Top up the special salt as follows:
Undo the screw plug on the
1.
dispenser 1b.
Fill the dispenser with water
2.
(required only when switching on the
appliance for the first time).
Add special salt as illustrated (do
3.
not use table salt or tablets).
The water is displaced and runs out.
*Depending on the features of your
dishwasher
Using detergent with a salt
component
I n general, you can use detergent with
D e t e r g e n t w i t h a s a l t c o m p o n e n t
a salt component up to a water
hardness level of 21 °dH (37 °fH, 26
°Clark, 3.7 mmol/L) without adding
special salt. Above a water hardness
value of 21 °dH, use additional special
salt.
Switching off salt refill
indicator/water softening unit
I f the salt refill indicator ): bothers
S w i t c h i n g o f f w a t e r s o f t e n i n g u n i t
you (e.g. if you are using a combination
detergent with a salt component), you
can switch off the salt refill indicator.
Proceed as described under "Setting
water softening unit" and set the value
to •:‹‹. The water softening unit and
the salt refill indicator are switched off.
*
21

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sx series

Table of Contents