Siemens SN series Instruction Manual page 49

Hide thumbs Also See for SN series:
Table of Contents

Advertisement

Fault
Plastic parts discoloured.
Removable streaks on
glasses, glasses with
metallic appearance and
cutlery.
Initial or existing
irreversible clouding of
glass.
Rust spots on the cutlery.
* Depending on the features of your dishwasher
Reason
Rinsing temperature too low.
Dishes precleaned too intensely;
sensors therefore opt for weak
programme sequence. Stubborn
soiling cannot be completely
removed.
Too much rinse aid.
No rinse aid added or setting too
low.
Detergent residue in the final
rinse. Detergent dispenser cover
blocked by dishes (cover does
not open fully).
Dishes precleaned too intensely;
sensors therefore opt for weak
programme sequence. Stubborn
soiling cannot be completely
removed.
Glasses not dishwasher-proof,
only suitable for dishwashers.
Cutlery is not sufficiently
rust-resistant.Knife blades are
frequently more severely
affected.
Cutlery will also rust if rusting
parts are rinsed at the same time
(pan handles, damaged utensil
baskets, etc.).
Salt content in the rinsing water
too high, as salt dispenser lock
not fastened firmly or salt was
spilled while being refilled.
Fault, what to do? en
Solution
Select programme with higher rinsing
temperature.
Do not prerinse dishes.Remove only large
food remnants.
Increase sensitivity of the sensors.
Recommended programme Eco 50°
Set rinse aid amount to a lower setting.
Add rinse aid and check dosage
(recommended level 4–5).
Detergent dispenser cover must not be
obstructed by dishes.
Do not place dishes or fragrance
dispenser in the tablet collecting tray.
Do not prerinse dishes.Remove only large
food remnants.
Increase sensitivity of the sensors.
Recommended programme Eco 50°
Use dishwasher-proof glasses.
Avoid long steam phase (standing time
after rinse cycle ends).
Use rinse cycle at lower temperature.
Set water softening system according to
the water hardness (if required, one
setting lower).
Use detergent with glass protection
component.
Use rust-resistant cutlery.
Do not wash rusting parts.
Fasten salt dispenser lock firmly or
remove spilled salt.
49

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sx series

Table of Contents