Interrupting The Programme; Terminating The Programme; Changing The Programme; Cleaning And Maintenance - Siemens SN series Instruction Manual

Interrupting the programme

Caution!
Expansion (overpressure) may cause
the appliance door to jump open and/or
water to escape! If the door was opened
on an appliance which has a hot water
connection or is heated, always leave
the door ajar for several minutes and
then close it.
Switch off ON/OFF switch (.
1.
The LEDs go out. The programme is
saved.
Switch on the ON/OFF switch (
2.
again to continue the programme.

Terminating the programme

(Reset)
Press the START button h and
1 .
T e r m i n a t i n g t h e p r o g r a m m e
hold it down for about 3 seconds.
The value ‹‹h:‹‚m appears in the
display window @. The
programme duration is about
1 minute. The value ‹‹h:‹‹m
appears in the display window @.
Press the ON/OFF switch (.
2.

Changing the programme

When the START button h has been
pressed, the programme cannot be
changed. The only way a programme
can be changed is by Cancel
programme (Reset).
Cleaning and maintenance en
2
Cleaning and
maintenance
A regular inspection and maintenance
C l e a n i n g a n d m a i n t e n a n c e
of your machine will help to prevent
faults. This saves time and prevents
problems.
Overall status of the
dishwasher
*The interior of your dishwasher is
predominantly self-cleaning. In order to
remove deposits, your dishwasher
automatically changes the running of
the programme (such as by increasing
the cleaning temperature) at certain
intervals. This will lead to higher
consumption values when running this
programme.
*Depending on the features of your
dishwasher
If you should find deposits in the
interior of the dishwasher in spite of
this, remove these deposits as
follows:
Fill the detergent dispenser 9: with
1.
detergent.
Select the programme with the
2.
highest temperature.
Start the programme without dishes.
3.
:
Warning
Health hazard due to detergents
containing chlorine!
Always use chlorine-free detergents.
39