Switching On The Appliance; Remaining Running Time Display; Time Preselection; Programme End - Siemens SN series Instruction Manual

en Operating the appliance

Switching on the appliance

Turn tap fully on.
1.
Switch on ON/OFF switch (.
2.
The Eco 50° programme has been
preset for environmentally friendly
operation whenever the appliance
starts. This programme remains
selected if no other programme
button 0 is pressed.
Press START button h.
3.
Programme sequence starts.
Note:
For ecological reasons the Eco 50°
programme is preset whenever the
appliance starts. This conserves
environmental resources and not least
saves you money.
The Eco 50° programme is a
particularly environmentally friendly
programme. According to EU
regulation 1016/2010 it is the
"Standard programme" which is the
most efficient standard cleaning cycle
for cleaning normally soiled utensils in
terms of the combined energy and
water consumption for cleaning these
types of utensils.
Remaining running time
display
When the programme is selected, the
remaining programme time is indicated
in the display window @.
The running time is determined during
the programme by the water
temperature, the quantity of dishes as
well as the degree of soiling and may
vary (depending on the selected
programme).
38

Time preselection *

* depending on the configuration of
T i m e p r e s e l e c t i o n
your specific dishwasher
You can delay the start of the
programme by up to 24 hours.
Here's how to set up the delay:
Switch on ON/OFF switch (.
1.
Press the timer programming button
2.
X - or +.
The display window @ shows
‹‹h:‹‹m.
Keep pressing the timer
3.
programming button X - or + until
the desired time is displayed.
Press START button h.
4.
The delay timer has been activated.
To clear the specified delay, press
5.
the button X - or + repeatedly until
the display window @ shows
‹‹h:‹‹m.

Programme end

The programme has finished when the
value ‹‹h:‹‹m appears in the display
window @.

Switching off the appliance

Shortly after the end of the
programme:
Switch off ON/OFF switch (.
1.
Turn off water supply (does not
2.
apply to appliances with Aqua-Stop).
Remove the utensils when they have
3.
cooled down.
When the programme ends,
Note:
leave the appliance to cool down a
while before opening it. This will prevent
steam from escaping and causing
long-term damage to your built-in
furniture.