Fault Table - Siemens SN278I01TG Instruction Manual

Fault table

Fault
Error code ":‚‰ is lit.
Error code ":‹ˆ is lit.
Error code ":‚ƒ is lit.
Error code ":‚... is lit.
Error code ":‚† is lit.
Error code ":‚‡ is lit.
Error code ":ƒƒ is lit.
Error code ":ƒ... is lit.
Cause
Supply hose kinked.
Tap turned off.
Tap jammed or calcified.
Filter in the water supply blocked. Switch off the appliance and pull out the
Intake opening (on right inside of
appliance) covered by utensils.
Heating element calcified or
soiled.
Water protection system
activated.
Constant water inflow.
Filters 1j are soiled or
blocked.
Waste-water hose kinked or
blocked.
Siphon connection still sealed.
Cover on the waste water pump
loose.
Fault, what to do? en
Remedial action
Install supply hose without kinks.
Turn on the tap.
Turn on the tap.
Flow rate must be min. 10 l/min. when
water supply is open.
mains plug. Turn off the tap. Unscrew
water connection.
Clean filter in the supply hose. Screw
water connection on again. Check for
leaks. Reconnect power supply. Switch on
the appliance.
Arrange utensils so that the intake
opening is not obstructed.
Clean appliance with dishwasher cleaning
agent or descaler. Operate the dishwasher
with water softening system and check the
setting.~ " Water softening
system/special salt" on page 15
Turn off tap.
Call customer service and mention the
fault code.
Clean filters. ~ "Filters" on page 36
Install hose without kinks, remove any
residue.
Check connection to siphon and open if
required.
Lock cover correctly. ~ "Waste water
pump" on page 38
39