Others - Epson SC-F2100 SERIES User Manual

SC-F2100 Series User's Guide
Have you optimized the temperature and
o
pressure of the heat press?
The temperature of the heat press decreases when
you press a T-shirt that has had pre-treatment liquid
applied. When pressing several T-shirts one after
another, check that the temperature of the heat press
is not lower than required. Also, the whiteness
becomes uneven if the pressure is insufficient since
the T-shirt does not dry completely and the fibers are
not pressed flat. Make sure you optimize the pressure
of the heat press.
"Fixating the Pre-treatment Liquid (Heat Press)"
U
on page 35
Try washing the ink tubes.
o
Because sedimentation occurs easily in White ink, the
whiteness may decline or become uneven if you
continue printing in white. Prepare the following
consumables when washing the tubes.
❏
White ink cartridges x2
❏
Cleaning cartridges x2
❏
Waste ink bottle
"Options and Consumable Products" on
U
page 114
"Tube Washing" on page 91
U
The under-base white is showing
outside the image
Adjust the print area of the under-base white
o
in the software.
The printed under-base white may show outside the
image depending on the material of the T-shirt and
the amount of ink fired. If this occurs, adjust the print
area of the under-base white from the printer's
Garment Creator software or the RIP software.
Problem Solver

Others

The control panel display keeps
turning off.
Is the printer in sleep mode?
o
Normal operation can be restored by pressing any of
the buttons in the control panel to reactivate the
display and then performing a hardware operation
such as opening the printer cover or sending a job to
the printer. You can select the time for shifting to sleep
mode from the Administrator Menu.
"Menu List" on page 96
U
Printing does not stop or printed text
is corrupted
Have you started Garment Creator and
o
software RIP over a USB connection?
Only start Garment Creator or software RIP. Do not run
them both at the same time.
111