LG WTP2071 series Owner's Manual page 15

2
Remove the guide plate if the tap is too large
to fit the adapter.
Guide plate
3
Push the adapter onto the end of the tap
so that the rubber seal forms a watertight
connection. Tighten the four fixing screws
and the adapter ring plate.
4
Pull the connector latch plate down, push the
supply hose onto the adapter, and release
the connector latch plate. Make sure the
adapter locks into place.
NOTE
• After connecting the supply hose to the water
tap, turn on the water tap to flush out foreign
substances (dirt, sand, sawdust, and etc.)
in the water lines. Let the water drain into a
bucket, and check the water temperature.
Latch plate
Connecting the Cold inlet hoses
to both Washing Machines
1
Connect the water supply hose connector
to the water supply hose of the Main
front-loading washing machine. Open the
accessory installation package of this Mini
Washer to find the Connector/Adaptor and
the short connection hose.
Water supply
hose connector
Press
board
2
Connect the the normal length supply hose of
Mini Washer to one end of the water supply
hose connector.
Rubber
packing
3
Connect the additionally provided water
supply hose of the Main front-loading
washing machine to another side of the
plastic water supply hose connector and then
finally connect one side of the Short Inlet
hose (supplied in the accessory package
of the Mini Washer) to the plastic 3 way
connector and the other end to the Cold
water tap.
Cold water supply hose
connector
EN
Rubber
packing
15