Error Messages - LG WTP2071 series Owner's Manual

Error Messages

Symptoms Reason
Drawer is not closed properly.
Lid is not closed properly.
Water supply tap is not fully
open.
Water line hose is kinked,
pinched, or crushed.
Water inlet filter is clogged.
Water supply pressure to tap
or house is too low.
Water supply connected with
leak-limiting hoses.
Drain hose is kinked, pinched,
or clogged.
Drain discharge is more than
100 cm above bottom of
washing machine.
Solution
• Close the drawer and press Start/Pause
button to start the cycle.
• If the drawer is closed and the drawer
lock error message is displayed, call for
service.
• Open the drawer and make sure the
latch area is free of clothing or other
obstructions.
• Close the Lid, shut the drawer, and press
Start/Pause to start the cycle.
• If the Lid is closed and the Lid error
message is displayed, call for service.
• Make sure that the water tap is fully open.
• Make sure that the hose is not kinked
or pinched. Be careful when moving the
washing machine during cleaning and
maintenance.
• Clean the inlet filter.
• Check another tap in the house to make
sure that household water pressure
is adequate and flow is not restricted.
Disconnect the supply hose from the
washing machine and run a few liters of
water through the hose to flush the water
supply lines. If flow is too low, contact a
plumber to have the water lines repaired.
• Hoses designed to limit leaks can trip
falsely and prevent the washing machine
from filling. The use of leak limiting hoses
is not recommended.
• Make sure the drain hose is free of clogs,
kinks, etc., and is not pinched behind or
under the washing machine.
• Adjust or repair drain. Maximum drain
height is 100 cm.
EN
37