Large Feed Roll Removal - Lexmark Optra Color 40 Service Manual

4092-010

Large Feed Roll Removal

1. Remove the front cover.
2. Remove the rear cover.
3. Remove the carrier frame assembly.
4. Using a small screwdriver, pry open the slot in the retainer clip
and remove it and the compound idler gear from the compound
idler stud.
5. Remove the large feed roll from the mid frame by pulling it out of
the four mounting clips. Spread the right side frame and remove
the large feed roll.
Note: Install the compound idler gear and retainer clip after the
printer is installed in the base assembly.
Repair Information
4-11