Power Up Troubleshooting - Raymarine RAY90 Installation And Operation Instruction Manual

11.4 Power up troubleshooting

Problems at power up and their possible causes and solutions are described here.
Product does not turn on or keeps turning off
Possible causes
Blown fuse / tripped breaker
Poor / damaged / insecure
power supply cable /
connections
Incorrect power connection
Power source insufficient
Product will not boot up (re-boot loop)
Possible causes
Power supply and connection
Software corruption
Product does not turn on or keeps turning off
Possible causes
Blown fuse / tripped breaker
Poor / damaged / insecure
power supply cable /
connections
Troubleshooting
Possible solutions
1. Check condition of relevant fuses and breakers and
connections, replace if necessary (Refer to
Technical specification
2. If fuse keeps blowing check for cable damage, broken
connector pins or incorrect wiring.
1. Check that the power cable connector is fully inserted into
the unit and locked in position.
2. Check the power supply cable and connectors for signs of
damage or corrosion, replace if necessary.
3. With the unit turned on, try flexing the power cable near
to the display connector to see if this causes the unit to
re-boot/loose power, replace if necessary.
4. Check the vessel's battery voltage, the condition of the
battery terminals and power supply cables, ensuring
connections are secure, clean and free from corrosion,
replace if necessary.
5. With the product under load, using a multi-meter, check for
high voltage drop across all connectors/fuses etc, replace
if necessary.
The power supply may be wired incorrectly, ensure the
installation instructions have been followed. (Refer to
Cables and connections
With the product under load, using a multi-meter, check the
power supply voltage as close to the unit as possible to establish
actual voltage when the current is flowing. (Refer to
Technical specification
Possible solutions
See possible solutions from 'Products does not turn on or keeps
turning off' above.
In the unlikely event that the products software has become
corrupted please try re-flashing the latest software from the
Raymarine website.
Possible solutions
1. Check condition of relevant fuses and breakers and
connections, replace if necessary (Refer to
Technical specification
2. If fuse keeps blowing check for cable damage, broken
connector pins or incorrect wiring.
1. Check that the power cable connector is fully inserted into
the unit and locked in position.
2. Check the power supply cable and connectors for signs of
damage or corrosion, replace if necessary.
for fuse ratings.)
for cable and connection requirements.)
for power supply requirements.)
for fuse ratings.)
Chapter 13
Chapter 4
Chapter 13
Chapter 13
141