Handset Station Connection; Connecting Handsets And Cables; Handset Extension Cables - Raymarine RAY90 Installation And Operation Instruction Manual

4.4 Handset station connection

A Wired handset can be connected to each Handset station connection (HS 1 / HS 2). Your radio is
supplied with the equipment to create a full handset station (i.e.: Wired handset, Adaptor cable and
Passive speaker). Additional accessories can be purchased to create a second wired handset station.
1. Base station
2. Passive speaker (1 x supplied and available as accessory: A80542)
3. Wired handset (1 x supplied and available as accessory: A80289)
4. Handset station adaptor cable with RCA Audio 400 mm (1.3 ft) (1 x supplied and available as
accessory: A80297)
5. Wired handset extension cable (Available optional accessories: A80290 – 5 m, A80291 – 10
m or 15 – A80292)
6. Panel mount fixings kit (1 x supplied and available as a Spare: R70438)

Connecting handsets and cables

Follow the steps below to connect handsets and extension cables together.
1. If fitted, unscrew and remove the dust cap from the relevant connector.
2. Ensure the cable connectors are correctly orientated, before insertion.
3. Ensure connectors are fully inserted, before locking..
4. Tighten locking collars by Rotating clockwise.

Handset extension cables

Handset station cabling can be extended using approved extension cables.
The maximum length of cable from the Handset to the Base station should not exceed 50 m (164 ft)
54