Burner Removal - DaVinci Maestro Collection Square Owner's Manual

Burner Removal

Burner removal is only required if extensive access is needed (installing glass panes on indoor/outdoor
units, extensive service, etc.). Follow the directions below to remove the burners.
a) Follow the directions on the previous page for accessing internal components (remove intake air
channel media tray).
b) Remove the front inner glass pane (see page 53).
c) Remove the screws holding the burner media trays in place (6 to 8 screws for each tray depending
upon length – see photos below).
d) Remove the media trays (use a flat screwdriver to pry up one edge). Make sure to notate the position
of the trays when removing. The screw holes will only line up if the tray is properly replaced.
© Travis Industries
Installation
(for qualified installers only)
9/25/17-1468
1/4" Nutdriver
17
Maestro