Table of Contents
Advertisement
•
The USB device must support USB 2.0.
•
The USB device must support the FAT32 or VFAT file type. The NTFS file type is not supported.
Because of hardware limitations, the write and read speed to and from a USB device is about 1 Mbps.
Note
In a stack, only the switch that functions as the master can detect and manage an
attached USB device.
Mini USB Console Port
The back panel of the switch provides one mini USB port for console access only. This port is configured
for 115200 baud, eight data bits, one stop bit, and no parity. The product package includes one USB console
cable with one mini B connector and one type A connector. You can use this cable to connect the mini USB
console port on the switch to a USB port on a VT100-compatible terminal or a Windows-based computer
that runs VT100 terminal emulation software.
Note
For you to be able to use the mini USB port and access the switch from a
Windows-based computer that runs VT100 terminal emulation software, you must
install the USB driver on the computer. The Windows USB driver is on the resource
CD in the product package.
Power Supply Units
The switch can support the following power supply unit (PSU) configurations for dual PSU configurations:
•
One APS600W PSU
•
Two APS600W PSUs
•
One APS1200W PSU
•
Two APS1200W PSUs
•
One APS600W PSU and one APS1200W PSU
The PSUs provide one AC OK LED. During normal operation, this LED lights green to indicate that the PSU
is receiving power.
For more information about the PSUs, see the NETGEAR Power Supplies Units for Managed Switches
Installation Guide, which you can download by visiting downloadcenter.netgear.com.
Fully Managed Stackable Switch M4300-96X
Hardware Overview
22
Advertisement
Table of Contents
Troubleshooting
