-
APM408F. Provides eight 1G/10GBASE-X SFP+ ports in which you can install 1G and 10G GBICs
or DACs.
-
APM402XL. Provides two 40GBASE-X QSFP+ ports in which you can install QSFP+ modules,
break-out cables, or DACs.
•
Support for 1.92 Tbps switching fabric (all ports line-rate).
•
One out-of-band 1G Ethernet port.
•
One RJ-45 RS232 console port.
•
One mini USB console port.
•
One regular USB port for connection to a storage device.
•
Two PSU bays for small form-factor modular PSUs.
•
Support for stacking on any 10G or 40G port.
•
Full-width, 2U chassis.
•
Full compatibility with IEEE standards:
-
IEEE 802.3 (Ethernet )
-
IEEE 802.3i (10BASE-T)
-
IEEE 802.3u (100BASE-TX)
-
IEEE 802.3ab (1000BASE-T)
-
IEEE 802.3an (10GBASE-T)
-
IEEE 802.3z (1000BASE-SX/LX)
-
IEEE 802.3ae (10GBASE-SR, 10GBASE-LR)
-
IEEE 802.3ba (40GBASE-SR4, 40GBASE-LR4, and 40GBASE-CR4)
-
IEEE 802.3x Full-duplex flow control
-
IEEE 802.3ad Link aggregation (LAG with LACP)
-
IEEE 802.3az Energy Efficient Ethernet (EEE)
-
IEEE 802.3af (PoE)
-
IEEE 802.3at (PoE+)
•
AutoSensing and autonegotiating capabilities for all ports.
•
Auto Uplink™ technology is supported on all ports.
•
Automatic address learning function to build the packet-forwarding information table. The table contains
up to 16K Media Access Control (MAC) addresses.
•
Store-and-forward transmission to remove bad packets from the network.
•
Active flow control to minimize packet loss and frame drops.
•
Half-duplex backpressure control.
•
Per-port status LEDs and system status LEDs.
•
Nonstop Forwarding Failover (NSF) support for the master in a stack.
Fully Managed Stackable Switch M4300-96X
Introduction
7