Connecting To The Console Port - NETGEAR M4500 Series Hardware Installation Manual

12 Slide the blue release tabs on the inner rails and push the switch all the way to the rear
of the rack.
13 Secure the switch to the rack using the screws.

Connecting to the Console Port

The console port is used for setting up and managing the switch via a connection to a
console terminal or PC using a terminal emulation program. You can connect the switch to a
terminal or PC using one of the supplied console cables for serial communication. (USB 2.0
male-to-RS-232 male cable; RJ-45 male-to-RS-232 female cable.)
Below is the console cable wiring specification table for the RJ-45 male-to-RS-232 female
cable:
RJ-45 Port of
Switch
3
6
5
Using the console port, you can perform the following:
 Configure the switch by using the Command Line Interface (CLI)
 Manage and monitor network activity by using the CLI
 Manage and monitor network activity by using Simple Network Management Protocol
(SNMP)
 Upgrade the firmware
DB9 Female Port of
PC
2
3
5
NETGEAR M4500 Series Switches Hardware Installation Guide 28
Hardware Installation
Abbreviation
RD Received Data
TD Transmit Data
GND Ground
Description