Table of Contents
Advertisement
To connect a PoE or non-PoE device to an RJ-45 port on an APM408C or APM408P port
card:
1.
Connect the device to an RJ-45 port on a port card.
2.
Verify that all cables are installed correctly.
Step 6: Install SFP or QSFP Transceiver Modules
If you do not use APM408F or APM402XL port cards, you can skip this step.
Install SFP Transceiver Modules
Note
If you do not use APM408F port cards, you can skip this step.
This procedure describes how to install an SFP transceiver module into an SFP+ port on an APM408F port
card.
To install an SFP transceiver module into an SFP+ port on an APM408F port card:
1.
Insert the transceiver module into the SFP+ port.
CAUTION:
2.
Press firmly on the flange of the transceiver module to seat it securely into the connector.
Figure 7. Inserting an SFP transceiver module
Fully Managed Stackable Switch M4300-96X
The edges of the SFP+ port opening are sharp. We recommend that you
do not touch the port opening with your fingers but use a tool to insert
the transceiver module.
Installation
30
Advertisement
Table of Contents
Troubleshooting
