Power The Ttx402 And Center The Trims; Trim Adjustment - Flyzone Micro Super Cub Manual

POWER THE TTX402 AND CENTER THE TRIMS

Leave the left stick
(throttle control) in
the minimum position
during setup.
Power switch "ON" .
INSTALLATION AND REMOVAL OF THE LIPO BATTERY
Keep hands clear of propeller during battery installation and removal.
Use two fingers to secure
connector during battery
installation and removal.
Disconnect and remove the battery after use by holding the battery lead with two fingers and removing the battery
from the lead with the other hand. Do not yank or jerk the battery from the aircraft. This could pull the TR421 Rx
board loose from the fuselage.
Full extent............. Centered ........... Full extent
Constant «beep» .....Single «beep» ..... Constant «beep»
Connect the LiPo to the battery.
6
Illuminated red light
indicates the TTX402
is powered and transmitting.
Center the rudder and
elevator trims.

TRIM ADJUSTMENT

Press battery into
place to secure.