Flyzone Micro Super Cub Manual page 8

Table of Contents

Advertisement

REVERSE THE CONTROL THROWS
ARM THE PROPELLER
Keep hands and onlookers clear of the propeller during arming and operation.
Throttle control stick is in the low
or minimum position.
ADJUSTMENT OF LINKAGES: ELEVATOR AND RUDDER
To increase or decrease the control throws, follow these steps. Be sure to unpower the model before attempting to
mechanically adjust the linkages.
Moving the pushrod outward
decreases the control throw
Moving the pushrod inward
increases the control throw
Unplug the battery from the plane before reversing
the control throws. Only perform this procedure if the
control surfaces move in the wrong direction.
Press and hold one of the corresponding
control surface trim buttons and cycle the
power to reverse any control surface.
Raise the throttle control stick
to the maximum or high position.
«Beep»
Control Surface
8
Return the throttle control stick to
the minimum position. «Beep Beep»
The motor is now armed.
Use caution when removing
and reinstalling the pushrod
in the control horn to avoid
accidentally disconnecting
the linkage from the Rx board.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Micro Super Cub and is the answer not in the manual?

Table of Contents