Table of Contents
Advertisement
To save the settings, slide the WRITE ENABLE switch gently to the right.
The extinguishing output levels will now be set and any significant variation detected in the monitoring
levels will be announced as an EXTING. O/P fault.
15 Panel operation – Access levels 1 and 2
15.1 Normal condition
Under normal conditions and in Manual & Auto mode, the ECU will have only the green Power On LED
lit. With the ENABLE CONTROL keyswitch off the LCD on the ECU will show:
In Manual only mode the ECU will have an additional, Manual only yellow LED lit and the LCD will show:
The ECU has 3 access levels. Access level 1 is available at all times and allows operation of SILENCE
BUZZER and the Lamp test function (hold down EXIT button for more than 2 seconds). Access level 2 is
enabled after operation of the front panel mounted ENABLE CONTROL keyswitch. Access level 3 allows
configuration options to be set on the ECU following operation of the WRITE ENABLE while in access
level 2 (ENABLE CONTROLS keyswitch operated).
15.2 Access level 2
When the ENABLE CONTROLS keyswitch is operated the LCD on the ECU will show:
Press the ENTER button to view the following menu options.
15.2.1 Disable Extinguishing release outputs.
To disable both of the Extinguishing release outputs, press the UP button on the module while at access
level 2.
The display will show:
Press the ENTER button to select this function. The display will show:
The yellow disabled LED on the ECU will be lit.
Turn the ENABLE CONTROL keyswitch off to leave the disablement active. To re-enable the
extinguishing outputs repeat the procedure above.
15.2.2 Disable Manual release
To disable all Manual release inputs (front panel mounted and remotely connected); press the UP button
on the module while at access level 2 until the module displays:
TM206
27 of 35
Issue 1.0
Advertisement
Table of Contents
