Testing And Operation; Maintenance - Kidde SLED177i User Manual

CAUTION! Early warning fire detection and visual notification is best
!
achieved by the installation of fire detection and visual notification equipment in
all rooms and areas of the household as follows: A smoke alarm and visual
notification device installed and interconnected in each separate sleeping area,
and visual notification equipment interconnected with heat, smoke, or CO
alarms in the living rooms, dining rooms, kitchens, hallways, attics, furnace
rooms, closets, utility storage rooms, basements, and attached garages.

6. TESTING AND OPERATION

! WARNING! THIS STROBE LIGHT IS EXTREMELY BRIGHT. DO NOT LOOK
DIRECTLY AT THE LIGHT .
TESTING: Push the test button on one of the interconnected alarms to activate
the test sequence for the alarm.
The controlling alarm will also send an activation signal through the
interconnecting wiring to the strobe light, and cause the strobe light to flash if
the strobe light and the interconnection wiring are working properly.
If the strobe does not activate check the fuse or circuit breaker supplying power
to the alarm circuit.
If the strobe does not activate perform the maintenance steps in the alarm's
User Guide.
Check the operation of the strobe light by executing a test on another
interconnected alarm.
TEST THE STROBE LIGHT AND YOUR ALARMS WEEKLY TO ENSURE
PROPER OPERATION.
OPERATION: The strobe light is operating once AC power is applied, the green
LED is illuminated, and testing is complete. When the strobe light is activated by
an interconnected alarm, it will flash for as long as the controlling alarm remains
active.

7. MAINTENANCE

STROBE LIGHT REMOVAL:
IF TAMPER RESIST PIN HAS BEEN USED, REFER TO "TAMPER RESIST LOCKING