Testing And Operation; Maintenance - Kidde SLED177iCA User Manual

1102-7202-00_RevA_SLED177iCA_MAN_EN:_
CAUTION! Early warning fire detection and visual notification is best
achieved by the installation of fire detection and visual notification equipment in
all rooms and areas of the household as follows:
A smoke alarm and visual notification device installed and interconnected in
each separate sleeping area, and visual notification equipment interconnected
with heat, smoke, or CO alarms in the living rooms, dining rooms, kitchens,
hallways, attics, furnace rooms, closets, utility storage rooms, and basements.

6. TESTING AND OPERATION

WARNING! THIS STROBE LIGHT IS EXTREMELY BRIGHT. DO NOT LOOK
DIRECTLY AT THE LIGHT WHEN THE LIGHT IS FLASHING.
TESTING: Push the test button on one of the interconnected alarms to activate
the test sequence for the alarm.
The controlling alarm will also send an activation signal through the
interconnecting wiring to the strobe light, and cause the strobe light to flash if
the strobe light and the interconnection wiring are working properly.
If no alarm sounds perform the maintenance steps in the alarm's User Guide.
Check the operation of the strobe light by executing a test on another
interconnected alarm.
TEST THE STROBE LIGHT AND YOUR ALARMS WEEKLY TO ENSURE
PROPER OPERATION.
OPERATION: The strobe light is operating once AC power is applied, and testing
is complete. When the strobe light is activated by an interconnected alarm, it
will flash for as long as the controlling alarm remains active.

7. MAINTENANCE

STROBE LIGHT REMOVAL:
IF TAMPER RESIST PIN HAS BEEN USED, REFER TO "TAMPER RESIST LOCKING
PIN" IN SECTION (5) FOR PIN REMOVAL INSTRUCTIONS.
2013.6.3 3:21 PM Page 9