Ricoh Camera RDC-i700 Operation Manual page 134

Problem
Display shut off Battery is exhausted
Auto power off activated
Remote control Obstruction between remote control
unit (optional) unit and camera sensor
will not work
Remote control transmitter or
camera sensor is dirty
Remote control lithium battery is
exhausted
LCD monitor Area captured by autofocus field
brightness and surrounding area have different
changes during light levels or location is dark
autofocus
operation
Vertical lines Phenomenon occurring with bright
appear on subject, known as smear
image phenomenon
Miscellaneous
Problem
CF card or PC Card incorrectly oriented
card will not go
into slot
Battery exhausted
Camera will not
operate in
Camera malfunction
response to
buttons and
switches
Date/time setting is incorrect
Date and time
are wrong
Battery removed
Date and time
were set but
disappeared
Erase menu not displayed
File will not
erase, or CF
card or PC card
File protected
will not format
Keep settings mode not enabled
Mode settings
have changed
Auto power off setting is disabled
Auto power off
will not activate.
Camera powered by AC adapter
(auto power off is automatically
disabled when powered by AC
adapter)
Beep disabled
Beep will not
sound
No image on Incorrect video-out signal method.
TV screen
Incorrect video I/O switch setting on
video equipment
132
Cause
Cause
Remedy
Charge battery.
Switch power on again.
Remove obstruction.
* Sensor at left top of LCD monitor.
Clean.
Replace with new CR2032 lithium battery.
No malfunction.
No malfunction.
Remedy
Insert correctly.
Charge battery.
Switch off power, switch on again and set
mode dial to (Still Picture) or
If problem persists, reset.
1. Remove battery from camera, switch
power on and reload battery.
2. Try operating again.
Set correct date and time.
Date setting is reset if battery is removed
for approx. 1 month. Set date again.
Set mode dial to (Play) and switch to
edit mode.
Cancel protect setting.
Enable keep settings mode.
Enable setting.
–
Set beep sound to [ON].
Select correct video-out signal method.
Check video I/O switch setting on video
equipment.
Page
P.15
P.24
–
–
–
–
–
Page
P.20
P.15
(Text).
–
P.39
P.39
P.89
P.112
P.100
P.116
P.117
–
P.117
P.119
–